8
Cisco Smart+Connected Remote 250 Reference Guide
OL-27366-02
Install and Use the Optional Recharging Kit
Figure 7
Replace the Cover
b.
Slide the battery cover into the slot and then push down until the cover is horizontal. Slide the cover
into the slot until it snaps into place.
Step 4
Attach the power supply to your recharging station
This section applies to recharging stations for existing or new remotes.
a.
Insert the small end of the USB cable into the back of the recharging station (inside the indentation)
and thread the power cord through the indentation in the station (
Figure 8
).
Note
You can thread the cord straight out or wind it around to the opposite end of the recharging
station.
Figure 8
Insert Power Cordthe Cover
b.
Attach the USB cable to the power supply.
–
Remove the plastic shield from the power supply.
–
Attach the correct power plug adapter to the power supply by sliding it into the power supply’s
slot until it clicks into place.
–
(Optional) To remove the power plug adapter, press the Push button and slide the plug out.
