11
Cisco Smart+Connected Remote 250 Reference Guide
OL-27366-02
Configure the Remote Control
Cisco Remote 250 (Offline)
If you have a Cisco Remote 250 that is offline, follow these steps:
1.
On the remote, press
List.
2.
Press Config.
3.
Select Recharge Station.
Press Yes.
Configure the Remote Control
Step 1
Start Control4 Composer Pro and connect to a Director.
Step 2
In the
System Design
view, (selected by default), select the room where the Cisco Remote will reside.
Step 3
In the
My Drivers
tab, locate the
SR-250
under the
User Interface
section.
Step 4
Double-click
SR-250
to add the device to the project tree.
Step 5
Identify the Cisco Remote 250:
a.
In the
Connections
view, click the
Network
tab.
b.
Select
System Remote Control SR-250
in the center pane.
c.
Click
Identify
(or right-click and choose
Identify
).
d.
When prompted to do so, press the center button four (4) times to have the device identify to the
system.
e.
When the MAC address appears in the window, click
Close
.
Step 6
View or change the Cisco Remote properties as needed in Composer Pro. In the
System Design
view’s
project tree, select the
System Remote Control SR-250
object to display the device’s properties.
The properties include:
•
Display Brightness
—Set the light level (brightness) of the screen backlight. Choose a percentage
from 0 (Off) to 100 (full brightness).
•
Keypad Brightness
—Set the light level (brightness) of the keypad backlight. Choose a percentage
from 0 (Off) to 100 (full brightness).
•
Sleep Mode
—Set how long the Cisco Remote stays awake after no activity. The default setting is
15 seconds, but can be extended up to 60 seconds or can be reduced down to 0 to conserve battery
life. Select wake on movement to wake the remote when picked up.
•
Battery Level
—Displays the current strength of the batteries.
•
Channel
—Displays the ZigBee channel set for the SR-250, which should match the ZigBee channel
for the Cisco Controller.
•
Gateway
—Displays the MAC address of the ZigBee Server (usually your Cisco Controller unless
you specify differently).
•
Network
:
–
MAC
—Displays the Cisco Remote MAC address.
–
Firmware Version
—Displays the current firmware version.
