12
Cisco Smart+Connected Remote 250 Reference Guide
OL-27366-02
Configure the Remote Control
•
Watch/Listen Button Behavior
—Select to start the most recently-used device.
Program the Programmable Buttons
On the Cisco Remote 250, you can program six (6) soft buttons (Red, Green, Yellow, Blue, *, and #) to
perform programmed activities. These buttons can be programmed to execute any of the A/V device’s
macros or IR codes. Program these options using the A/V device Properties page.
Step 1
Start Composer Pro and connect to a Director.
Step 2
Ensure the
System Design
view is selected.
Step 3
Ensure that you have the following devices in your project:
•
Cisco Controller
•
System Remote Control SR-250
•
An A/V device to be controlled
Step 4
Select the
Connections
view.
Step 5
On the
Network
tab, ensure the
Controller
and the
System Remote Control
are both network identified
(have a network address).
Step 6
Program the programmable buttons (Red, Green, Yellow, Blue, *, or #) either based on the selected A/V
device or the selected room.
Figure 1-11
Programmable Buttons
