10
Cisco Smart+Connected Remote 250 Reference Guide
OL-27366-02
Install and Use the Optional Recharging Kit
Figure 10
Ensure Proper Installation
Recharging Station Lights
This section applies to recharging stations for existing or new remotes.
Depending on the Charging Indicator brightness you select, the indicator light will be High or Low
brightness or Black/Off. When your recharging station is on, you may see the following lights.
•
Red—The remote is recharging, and is not fully charged yet.
•
Green—The remote is fully charged.
•
Black—The light is off. Either the Charging Indicator is turned off, or the remote is not seated
properly in the recharging station.
Set Up Your Existing Remote for the Recharging Station
You must update your remote to recognize the new rechargeable battery.
(Optional) You can check
Enable Recharge Station
in Composer Pro (SR-150 or SR-250 remote
Properties page) to acknowledge the battery. This view also shows you the percent battery level.
Cisco Remote 250 (Online)
If you have a Cisco Remote 250 that is online, follow these steps:
1.
On the remote, press List.
2.
Press Info.
3.
Press Config.
4.
Select Recharge Station.
5.
Press Yes.
