Configuring Virtual Private Networks (VPNs) and Security
SSL VPN Tunnel Client Configuration
Cisco RV220W Administration Guide
138
6
Configured Client Routes for Split Tunnel Mode
Client routes are required if you enabled Split Tunnel mode for SSL VPN clients.
The Configured Client Routes entries are added by the SSL VPN Client such that
only traffic to these destination addresses is redirected through the SSL VPN
tunnels, and all other traffic is redirected using the hosts (SSL VPN Clients) native
network interface. For example if the SSL VPN Client attempts to access this
device’s LAN network then in Split Tunnel mode, the user should add the LAN
subnet as the Destination Network using this page.
•
Managing Client Routes, page 138
•
Configuring a Client Route, page 139
Managing Client Routes
Use the
VPN > SSL VPN Client > Configured Client Routes
page to configure
client routes. This feature is available only if you enabled Split Tunnel Support on
the
SSL VPN Client
page.
To open this page:
In the navigation tree, choose
VPN
> SSL VPN Client >
Configured Client Routes
.
Perform these tasks:
•
To add a route, click
Add
. Then enter the settings on the
SSL VPN Client
Route Configuration
page. See
Configuring a Client Route, page 139
.
•
To edit a route, check the box and then click
Edit
. Then enter the settings on
the
SSL VPN Client Route Configuration
page. See
Configuring a Client
Route, page 139
.
•
To delete a route, check the box and then click
Delete
. To select all routes,
check the box in the heading row, and then click
Delete
. When the
confirmation message appears, click
OK
to continue with the deletion, or
otherwise click
Cancel
.