5-7
Cisco Redundant Power System Hardware Installation Guide
OL-3654-01
Chapter 5 Troubleshooting the Cisco RPS
Error Messages on Cisco 2600 Series and Cisco 3620, Cisco 3640, and Cisco 3725 Routers
Note
Cisco 2600 series, Cisco 3620, Cisco 3640, and Cisco 3725 routers report the
failure of any of the Cisco RPS DC output modules, including the DC output
modules to which they are not directly connected.
SNMP Trap Issued Upon Error:
ciscoEnvMonRedundantSupplyNotification is generated.
The varbinds included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState.
The value of ciscoEnvMonSupplyState is a warning.
How to Correct Error:
Check the DC LEDs on the front panel of the Cisco RPS to determine which cable
is loose or if the module has failed, and try the corrective actions described in
Table 5-1
.
Console Message Issued Upon Correction of Error:
•
When an external device console monitor screen displays the Cisco IOS
software prompt (
routername>
or
routername#
)
Redundant Power Supply DC condition is now normal.
•
When an external device console monitor screen displays the ROMMON
prompt (
rommon#>
), no console message is issued when the error is corrected.
SNMP Trap Issued Upon Correction of Error:
ciscoEnvMonRedundantSupplyNotification is generated.
The varbinds included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState.
The value of ciscoEnvMonSupplyState is a warning.
AC Failure
LED status:
AC LED 1 or 2 is amber or off.