Step 5
Use a Phillips-head screwdriver to install the supplied screws and cap nuts that secure the VS-F6K-PFC4XL= to the
Supervisor Engine 2T.
Figure 4: Installing the Supplied Screws
You must use all the screws. The screws provide grounding between the policy feature card and the supervisor
engine. Failure to use and tighten all screws will invalidate the safety approval and pose a fire and electrical
hazard.
Caution
Use the supplied screws and cap nuts to secure the policy feature card to the supervisor engine.
Note
Step 6
Install the supervisor engine in the switch chassis.
Refer to the
Catalyst 6500 Series Switch Module Installation Guide
for installation instructions.
What to Do Next
1
If you are installing a policy feature card on a redundant supervisor engine, repeat the procedure for removing the supervisor
engine and install the same policy feature card there as well. See topic
Preparing the Supervisor Engine, on page 4
.
2
Power up the switch.
7
