Cisco ONS 15454, Руководство по процедурам

Страница: 122 / 175

1-34
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
78-19286-01
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Required Tools and Equipment (ETSI)
Warning
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950-1 based safety standards.
Statement 1033
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. The short-circuit
(overcurrent) protection rating must not exceed 40A.
Statement 1045
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Caution
Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed
instructions on how to wear the ESD wristband, refer to the
Cisco ONS Electrostatic Discharge (ESD)
and Grounding Guide.
Step 1 Verify that the correct fuse and alarm panel is installed in the top mounting space:
• (ETSI only) Verify that the fuse rating does not exceed 40A.
•
The fuse rating for ANSI chassis must not exceed 30A.
Step 2 Depending on your type of shelf, connect the office ground to the 15454 ETSI or the 15454 ANSI
chassis. For detailed instructions on grounding, refer to the
Cisco ONS Electrostatic Discharge (ESD)
and Grounding Guide .
Step 3
Depending on your shelf, complete the “DLP-G17 Connect Office Power to the ONS 15454 ETSI” task
on page 1-35 or the “DLP-G18 Connect Office Power to the ONS 15454 ANSI” task on page 1-37 .
Step 4 Complete the “DLP-G19 Turn On and Verify Office Power” task on page 1-39 .
Step 5 Continue with the “NTP-G8 Install the Fan-Tray Assembly” procedure on page 1-41 .
Stop. You have completed this procedure.