Cisco Nexus 7706, Руководство по установке оборудования

Страница: 77 / 190

switch(config)#
reload
Overview of Supervisor Modules
The switch has one or two supervisor modules of the following types:
• Supervisor 2 Enhanced (N77-SUP2E)
• Supervisor 3 Enhanced (N77-SUP3E)
You can use only one type of supervisor module in a switch. Note
When a switch has two supervisors, one supervisor is automatically active while the other is in standby mode.
If the active supervisor goes down or is disconnected for replacement, the standby supervisor automatically
becomes active. If you need to replace one of two installed supervisor modules with another module, you can
do this without interrupting operations—the supervisor that you are not replacing becomes the active supervisor
and retains the kickstart configuration while you replace the other supervisor.
If the switch has just one supervisor, you can install the new supervisor in the open supervisor slot during
operations and make that supervisor active after the installation.
Supervisor modules are automatically powered up and started with the switch.
Shutting Down a Supervisor Module
To shut down a supervisor module, use the out-of-service module command to specify the chassis slot with
that module.
Step 1
Start the configuration mode by entering the configure terminal command.
Example:
switch#
configure terminal
switch(config)#
Step 2
Take the supervisor module out of service by entering the out-of-service module slot_number command.
Example:
switch(config)#
out-of-service module 3
switch(config)#
Overview of I/O Module Support
The following table lists the I/O modules supported by the switch.
Cisco Nexus 7706 Hardware Installation Guide
65 OL-31330-01
Managing the Switch
Overview of Supervisor Modules