22
Cisco MS200X Series 10/100 24-Port Ethernet Access Switches
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [
Y
]?
S
TEP
6
Select
Y
, and enter a new administrator password.
You are now ready to configure the switch. Refer to the
Cisco
MS200X Series 24-Port 10/100 Ethernet Access Switches
Command Line Reference
for further information.
N
OTE
Make sure that any configuration changes made are saved
before exiting.
Troubleshoot Your Connection
If you cannot access your switch from the web-based interface, the switch
may not be reachable from your computer. You can test network
connections by using
ping
on a computer running Windows:
S
TEP
1
Open a command window by using
Start
>
Run
and enter
cmd
.
S
TEP
2
At the
Command
window prompt enter
ping
and the switch IP
address. For example
ping 192.168.1.254
(the default static IP
address of the switch).
If you can reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Reply from 192.168.1.254:bytes=32 time<1ms TTL=128
If you can reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Request timed out.
Returning the MS200X Switch to the
Factory Default Settings
To use the
RESET
button to reboot or reset the switch, do the following:
•
To
reboot
the switch, press the
RESET
button for less than ten seconds.
•
To
restore
the switch to its factory default settings, press-and-hold the
RESET
button for more than ten seconds.
6
