Cisco DVB CAR100 Series, Инструкция по эксплуатации

Страница: 3 / 10

3
English
Installing the Cisco DVB CAR100
This section provides basic information necessary to install the Cisco DVB CAR100. Refer to the Cisco DVB CAR100
Cable Access Router Hardware Installation Guide for detailed installation instructions and illustrations.
The following figure shows the locations for connecting all cables to the rear panel connectors of the Cisco DVB
CAR100.
Step 1
Connect the Cisco DVB CAR100 to the CATV network:
Connect the coaxial cable to the CATV wall outlet and to the socket labelled Cable on the rear of the Cisco
DVB CAR100.
Step 2
Connect the Cisco DVB CAR100 to the computer or hub:
If you have the Cisco DVB CAR100-PC, use a crossover Ethernet cable to connect the socket labelled
Ethernet to the computer’s Ethernet network adapter. If you have the Cisco DVB CAR100-LAN, use a
straight-through Ethernet cable to connect the socket labelled Ethernet to the hub’s Ethernet network
adapter.
Step 3
Cisco DVB CAR100-LAN only:
Connect the computers to the Ethernet hub according to the hub manufacturer’s instructions.
Step 4
Connect the power supply unit to the socket labelled Power on the back of the Cisco DVB CAR100, then
connect the power supply unit to the electrical wall outlet.
Note
Always use the power supply unit supplied with the Cisco DVB CAR100.
Power Ethernet Cable
38045