15-18
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
OL-27038-01
Chapter 15 First-Time Setup
Setting Up CTS Components
Step 5
Adjust the focus on the camera by performing the following steps:
a.
Loosen the thumbscrew for the lens focus ring. The ring is labeled “NEAR and FAR”.
Figure 15-12
Location of Focus and Zoom Rings
Use the thumbscrew (or 0.9 mm Allen wrench) to unlock the focus ring.
b.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
c.
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
d.
Continue to twist the focus ring until the red and green bars are approximately the same length.
e.
Make any additional adjustments you need to make to the zoom adjustments.
Occasionally, adjusting the focus can slightly change the zoom.
f.
Click
Hide Focus Targets
, then click
Done
when you complete the adjustment.
Step 6
Remove the targets and place them in front of the left camera.
Step 7
Complete
through
for the left camera.
Step 8
Remove the targets and place them in front of the right camera.
Step 9
Complete
through
for the right camera.
Attaching the Camera Hood Assembly, Top Bezel, and Service Panels and Aligning the Rear Panels
After you complete the camera adjustment, attach the camera hood assembly, top bezel, and Service
Panels and, if required, adjust the outside system panels by completing the following steps:
