3-14
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
For more information on the GUI administrator account, see
Setting Up a GUI Administrator Account,
page 3-16
.
Step 14
At the
Use Static IP Address [Yes]:
prompt, type
Y
for yes or
N
for No, and then press
Enter
.
Note
To set or change the IP address of your ACS SE, it must be connected to a working Ethernet
connection.
Note
A static IP address must be assigned to your ACS SE. You can set the IP address directly by
answering
Y
to this step and performing the substeps detailed in
Step 15
. Alternatively, you may
use a DHCP address if it assigns a single IP address that does not change.
Step 15
The following prompts appear only if you set a static IP address manually.
Otherwise the following
message appears:
No change to the configuration.
Accept network setting [Yes]
a.
To specify the ACS SE IP address, at the
IP Address [xx.xx.xx.xx]:
prompt, type the IP address,
and then press
Enter
.
b.
At the
Subnet Mask [xx.xx.xx.xx]:
prompt, type the subnet mask value, and then press
Enter
.
c.
At the
Default Gateway [xx.xx.xx.xx]:
prompt, type the default gateway value, and then press
Enter
.
d.
At the
DNS Servers [xx.xx.xx.xx]:
prompt, type the address of any DNS servers that you intend
to use (separate each by a single space), and then press
Enter
.
Note
If you do not intend to use a DNS server, enter the IP address of the ACS SE at the
DNS
Servers [xx.xx.xx.xx]:
prompt. If you do not configure the ACS SE to use a DNS server,
you must respond to all prompts for
hostname or IP address
only with an IP address.
Result
:
The system displays the new configuration information followed by this message:
IP Address is reconfigured.
e.
At the prompt,
Confirm the changes? [Yes]:
type
Y
, and then press
Enter
.
Result
:
The system displays the following message:
New ip address is set.
Default gateway is set to
xx.xx.xx.xx
DNS servers are set to:
xx.xx.xx.xx
xx.xx.xx.x
x.
f.
At the prompt,
Test network connectivity [Yes]:
, type
y
or
Y
, and then press
Enter
.
Tip
This step is essentially executing a
ping
command to ensure the connectivity of the ACS SE.
g.
At the prompt,
Enter hostname or IP address:
, type the IP address or hostname of a device
connected to the ACS SE, and then press
Enter
.
Result
:
If successful, the system displays the ping statistics. The system displays the prompt:
Test
network connectivity [Yes]:.
