Cisco Catalyst Blade 3032, Руководство по настройке программного обеспечения

Страница: 864 / 1380

37-44
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-06
Chapter 37 Configuring QoS
Configuring Standard QoS
Beginning in privileged EXEC mode, follow these steps to define the default CoS value of a port or to
assign the default CoS to all incoming packets on the port:
To return to the default setting, use the no mls qos cos { default-cos | override } interface configuration
command.
Configuring a Trusted Boundary to Ensure Port Security
In a typical network, you connect a Cisco IP Phone to a switch port, as shown in Figure 37-11 on
page 37-42 , and cascade devices that generate data packets from the back of the telephone. The Cisco IP
Phone guarantees the voice quality through a shared data link by marking the CoS level of the voice
packets as high priority (CoS = 5) and by marking the data packets as low priority (CoS = 0). Traffic sent
from the telephone to the switch is typically marked with a tag that uses the 802.1Q header. The header
contains the VLAN information and the class of service (CoS) 3-bit field, which is the priority of the
packet.
For most Cisco IP Phone configurations, the traffic sent from the telephone to the switch should be
trusted to ensure that voice traffic is properly prioritized over other types of traffic in the network. By
using the
mls qos trust cos interface configuration command, you configure the switch port to which
the telephone is connected to trust the CoS labels of all traffic received on that port. Use the mls qos
trust dscp interface configuration command to configure a routed port to which the telephone is
connected to trust the DSCP labels of all traffic received on that port.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Specify the port to be configured, and enter interface configuration mode.
Valid interfaces include physical ports.
Step 3 mls qos cos { default-cos | override } Configure the default CoS value for the port.
•
For default-cos, specify a default CoS value to be assigned to a port. If
the packet is untagged, the default CoS value becomes the packet CoS
value. The CoS range is 0 to 7. The default is 0.
•
Use the override keyword to override the previously configured trust
state of the incoming packet and to apply the default port CoS value to
the port on all incoming packets. By default, CoS override is disabled.
Use the override keyword when all incoming packets on specified ports
deserve higher or lower priority than packets entering from other ports.
Even if a port was previously set to trust DSCP, CoS, or IP precedence,
this command overrides the previously configured trust state, and all
the incoming CoS values are assigned the default CoS value configured
with this
command. If an incoming packet is tagged, the CoS value of
the packet is modified with the default CoS of the port at the ingress
port.
Step 4
end Return to privileged EXEC mode.
Step 5 show mls qos interface Verify your entries.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.