1-16
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-06
Chapter 1 Overview
Default Settings After Initial Switch Configuration
•
Switch LEDs that provide port- and switch-level status on nonstacking-capable switches
•
Switch LEDs that provide port-, switch-, and stack-level status on stacking-capable switches
•
MAC address notification traps and RADIUS accounting for tracking users on a network by storing
the MAC addresses that the switch has learned or removed
•
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) for traffic monitoring on any port or
VLAN
•
SPAN and RSPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report
network security violations
•
Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
•
Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
•
Layer 2 traceroute to identify the physical path that a packet takes from a source device to a
destination device
•
Time Domain Reflector (TDR) to diagnose and resolve cabling problems on 10/100 and
10/100/1000 copper Ethernet ports
•
SFP module diagnostic management interface to monitor physical or operational status of an SFP
module
•
Online diagnostics to test the hardware functionality of the supervisor engine, modules, and switch
while the switch is connected to a live network
•
On-board failure logging (OBFL) to collect information about the switch and the power supplies
connected to it
•
Digital optical monitoring (DOM) to check status of X2 small form-factor pluggable (SFP) modules
•
Enhanced object tracking (EOT) for HSRP to determine the proportion of hosts in a LAN by tracking
the routing table state or to trigger the standby router failover
•
IP Service Level Agreements (IP SLAs) support to measure network performance by using active
traffic monitoring
•
IP SLAs EOT to use the output from IP SLAs tracking operations triggered by an action such as
latency, jitter, or packet loss for a standby router failover takeover
•
Support for Embedded Event Manager (EEM) for event detection and recovery within a Cisco IOS
device, and EEM 3.2, which introduces event detectors for Neighbor Discovery, Identity, and
MAC-Address-Table
•
Memory consistency check routine enhancements to detect and correct invalid ternary content
addressable memory (TCAM) table entries that can affect switch performance
•
IETF IP-MIB and IP-FORWARD-MIB(RFC4292 and RFC4293) updates to support the IP version 6
(IPv6)-only and the IPv6 part of the protocol-version independent (PVI) objects and tables
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation, requiring only that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system- and stack-wide settings.
Содержание Catalyst Blade 3032
Страница 46: ...Contents xlvi Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide OL 13270 06 ...
Страница 50: ...lii Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide OL 13270 06 Preface ...
Страница 1380: ...Index IN 54 Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide OL 12189 06 ...