Installing the MCU MSE 8510
5
Installing the MCU MSE 8510
Step one: Install the MCU MSE 8510 into the MSE 8000 chassis
1
Remove the blade or blanking blade from the slot into which you are going to
install the MCU MSE 8510:
i
Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches
with an anti-clockwise quarter turn.
ii
Open both retaining latches on the front of the blade or blanking blade.
When open, a retaining latch is at a 90
°
angle perpendicular to the front of
the blade.
Important
: Before installing the MCU MSE 8510 into the MSE 8000,
read the safety information guide for the MSE 8000 chassis at
http://www.cisco.com/go/telepresence/safety
.
Although blades are hot-swappable parts, you must only remove one
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
Before hot-swapping a blade, shut down the blade using the web interface.
Do not shut down a blade during a software upgrade or if the blade is
processing (for example if a conference is taking place on a blade).
The MSE 8000 backplane uses high performance data connectors. Do not
remove MCU MSE 8510 blades unless necessary because doing so may
reduce the life of these connectors.
Make sure that you have the correct power requirements and sufficient
power in your PSU; for information on powering the MSE 8000 refer to
the
Getting Started Guide
on
http://www.tandberg.com/support/video-
conferencing-documentation.jsp
).
You must install either a blade or a blanking blade in each of the ten
positions in the chassis.
The Supervisor blade must be installed into slot 1 of the MSE 8000
chassis.
!
!
!
!
!
!
