Cisco ASR 1000 Series, Руководство по настройке программного обеспечения, Страница: 333 / 602

Saving the Configuration
To save your running configuration to nonvolatile random-access memory (NVRAM), use the following
command in privileged EXEC configuration mode:
Purpose Command
Writes the new configuration to NVRAM. Router# copy running-config startup-config
For more information about managing your system image and configuration files, refer to the Cisco IOS
Configuration Fundamentals Configuration Guide and the Cisco IOS Configuration Fundamentals Command
Reference publications for your Cisco IOS software release.
Verifying the Interface Configuration
Besides using the
show running-configuration
command to display your Cisco ASR 1000 Series Routers
configuration settings, you can use the show interfaces serial and the show controllers serial commands
to get detailed information on a per-port basis for your 2-Port and 4-Port Channelized T3 SPA.
Verifying the Per-Port Interface Status
To find detailed interface information on a per-port basis for the 2-Port and 4-Port Channelized T3 SPA, use
the
show interfaces serial command.
The following example provides sample output for the serial interface:
Router# show interface serial4/0/0
Serial4/0/0 is down, line protocol is down
Hardware is SPA-4XT-SERIAL
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
Reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Restart-Delay is 0 secs
Last input never, output never, output hang never
Last clearing of show interface counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
RTS down, CTS down, DTR down, DCD down, DSR down
To find detailed status and statistical information on a per-port basis for the 4-Port Serial Interface SPA, use
the
show controllers serial command:
Router# show controllers serial 2/0/0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 287
Configuring the 4-Port Serial Interface SPA
Saving the Configuration