Cisco Aironet 1430 Series, Руководство по началу работы, Страница: 14 / 48

14
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
What To Do Next
After your bridge has basic settings, you need to complete your bridge’s configuration. You might need
to adjust the output power level and other network and security settings.
Output Power Level
Your bridge’s output power level might require adjustment under the following conditions:
•
When bridges are installed less than 328 ft (100 m) apart, you should reduce their output power
to avoid overloading the bridge’s receivers.
To configure your bridge’s output power level, refer to the Power Levels and Channels for Cisco
Aironet Access Points and Bridges .
IP Address Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 10.0.0.1
IP Subnet Mask Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 255.255.255.224
Default Gateway Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 0.0.0.0
SNMP defaultCommunity
Read Only
SSID autoinstall
1
Broadcast SSID in Beacon Yes
Role in Radio Network Install
Optimize Radio Network for Throughput
1. During Install Mode, the SSID is autoinstall .
Table 1 Default Settings on the Express Setup Page (continued)
Setting Default
br1430gsg.fm Page 14 Thursday, November 20, 2008 1:59 PM