3-11
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 3 Configuring Ports and Interfaces
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
AP-Manager Interface
•
VLAN identifier
Note
Enter
0
for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
•
Fixed IP address, IP netmask, and default gateway
Note
The AP-manager interface’s IP address must be different from the management interface’s
IP address but must be on the same subnet as the management interface.
•
Physical port assignment
•
Primary and secondary DHCP servers
•
Access control list (ACL) name, if required
Note
To create ACLs, follow the instructions in
Chapter 5
.
Virtual Interface
•
Any fictitious, unassigned, and unused gateway IP address, such as 1.1.1.1
•
DNS gateway host name
Service-Port Interface
Note
The service-port interface uses the controller’s factory-set service-port MAC address.
•
DHCP protocol (enabled) or
•
DHCP protocol (disabled) and IP address and IP netmask
Step 4
Click
Save Configuration
to save your changes.
Step 5
If you made any changes to the virtual interface, reboot the controller so your changes take effect.