3-29
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 3 Configuring Ports and Interfaces
Enabling Link Aggregation
LAG is typically configured using the Startup Wizard, but you can enable or disable it at any time
through either the GUI or CLI.
Using the GUI to Enable Link Aggregation
Follow these steps to enable LAG on your controller using the GUI.
Step 1
Click
Controller
>
General
to access the General page (see
Figure 3-13
).
Figure 3-13 General Page
Step 2
Set the LAG Mode on Next Reboot parameter to
Enabled
.
Note
Choose
Disabled
if you want to disable LAG.
Step 3
Click
Save Configuration
to save your changes.
Step 4
Reboot the controller.