2-7
Cisco Video Surveillance 7530PD IP Camera Installation Guide
Chapter 2 Camera Installation
Installing the IP Camera with a Vandal Resistant Enclosure
Note
There are 8 holes on the seal (D), and the widest holes with a crack on the side are specific
for power cables.
d.
Feed the I/O cables through the waterproof connector (F --> E --> D --> B --> A). Be sure to feed
enough I/O cable length through the waterproof connector to connect the I/O cable to the GPIO
block.
The recommended cable gauge is 2.0 through 2.8 mm.
e.
Push the seal (D) into the housing (B).
f.
Insert the seals (C) into unused holes on the seal (D) to avoid moisture.
g.
Secure the sealing nut (A) tightly and hex nut (F) from the bottom of the camera.
h.
Connect the power and I/O cables to the GPIO terminal block.
Step 7
Use the included L-type wrench to secure the conduit base to the mounting plate with the three included
screws.
Pin
Description
1
24 VAC
2
24 VAC
3
RS485–
4
RS485+
5
DI–
6
DI+
7
DO–
8
DO+
8
7
6
5
4
3
2
1
