Cisco 7300-1OC12POS-MM, Руководство по установке и настройке

Страница: 37 / 50

C H A P T E R
4-1
OC12 Packet Over SONET Line Card Installation and Configuration
OL-3437-01
4
Configuring the OC12 POS Line Card
To continue your OC12 POS line card installation, you must configure the OC-12 interface. This chapter
contains the following sections:
•
Using the EXEC Command Interpreter, page 4-1
• Configuring the Interfaces, page 4-2
•
Checking the Configuration, page 4-7
• OC12 POS Statistics Counters, page 4-12
•
OC12 POS Line Card Error Messages, page 4-13
• CLI-Controlled OIR, page 4-13
Using the EXEC Command Interpreter
You modify the configuration of your router through the software command interpreter called the EXEC
(also called enable mode). You must enter the privileged level of the EXEC command interpreter with
the enable command before you can use the configure command to configure a new interface or change
the existing configuration of an interface. The system prompts you for a password if one has been set.
The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket (>).
At the console terminal, use the following procedure to enter the privileged level:
Step 1
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
privileged-level password as follows:
Router> enable
Password:
Step 2 Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
When you enter the correct password, the system displays the privileged-level system prompt (#):
Router#
To configure the new interfaces, proceed to the “Configuring the Interfaces” section on page 4-2 .