Cisco 6823, Руководство администратора

Страница: 61 / 194

Do not connect the repeater to power until Step 6.
When you power on a new repeater, it tries to register with the base station, and this registration needs to
happen within 5 minutes.
Note
The repeater reboots at the end of its configuration. This is normal because it has set up encrypted
communications. After the reboot, it is ready to use.
Before you begin
Connect to the base station web page as described in Sign in to the Administration Web Page, on page 42 .
Procedure
Step 1
Click Repeaters .
Step 2 Click Add Repeater .
Step 3 Set the DECT sync mode field.
• Manual : You need to manually assign parameters.
• Local Automatic : The repeater detects the base signal and automatically configures.
Step 4 For manual configuration, select a Repeater RPN from the dropdown menu.
Each repeater needs a unique RPN.
• Single cell systems: The base is always RPN000. The first repeater is RPN01, the second RPN02, and
so on.
• Multicell systems: The base numbers increment by 4 (RPN00, RPN04, and so on). The first repeater for
the first base station is RPN01, the second RPN02. The first repeater for the second base station is RPN05,
the second RPN06.
Step 5 Click Save .
Step 6
Power on the repeater.
The repeater LED will flash green (two short flashes) to indicate registration mode. When registration completes,
the repeater and base station reboot to set up encrypted communications.
If you powered on the repeater before you completed step 5 and the repeater LED is red, the repeater won't
register. You must follow the information in
Can't Set Up a Repeater - LED is Red, on page 164 to get the
repeater into registration mode.
Change the Handset Information
You can configure common handset information like the access code, alarm information, shared lines, and
the phone book.
Cisco IP DECT 6800 Series Administration Guide
53
Phone Administration
Change the Handset Information