Cisco 675 - 675 Router, Инструкция по установке и эксплуатации

Страница: 100 / 192

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Create Routing Tables
5-16
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 2
To set an upstream ScalaRate for a particular VC, enter:
cbos# set interface wan0-0 rate 512
Step 3
To set an upstream ScalaRate to the maximum allowable rate, enter:
cbos# set interface wan0-0 rate auto
Step 4
To save your changes, enter:
cbos# write
Step 5
To exit the CBOS, enter:
cbos# quit
Create Routing Tables
In order to pass data through a network and onto the Internet or wide area network,
you might need to add the IP address(es) of gateway(s) to the routing table. Follow
the instructions below to build a routing table manually by adding or deleting
entries in the table.
Note
If your Cisco 67x was provisioned to run in bridging or PPP routing
mode, you must disable both before attempting to establish routing.
Step 1
To add a route and gateway to IP address 192.168.9.1, without specifying a
specific mask or metric, enter:
set route add ip 192.168.9.1 gw 192.168.10.250
Step 2 To add a route and specify a netmask, gateway, or metric, enter:
set route add ip 192.168.10.0 mask 255.255.255.0
gw 192.168.245.228 metric 1
Step 3
To set a default route, enter:
set route default 192.168.245.228