2.
Move the Cisco VG450 Voice Gateway power switch to the ON position.
3.
Enter
no
to proceed with manual configuration using the CLI:
4.
Press Return to terminate autoinstall and continue with manual configuration.
5.
Press Return to bring up the Router> prompt:
6.
Enter privileged EXEC mode:
7.
Continue with the
Troubleshooting
section.
DETAILED STEPS
Step 1
Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.
Step 2
Move the Cisco VG450 Voice Gateway power switch to the ON position.
The green LED next to the auxiliary port come on and the fan starts to operate. If this does not happen, see the
Troublehooting
section in this guide.
The following message is displayed at the end of the boot-up messages:
Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
Step 3
Enter
no
to proceed with manual configuration using the CLI:
Example:
Would you like to enter the initial configuration dialog? [yes/no]:
no
Would you like to terminate autoinstall? [yes]
Step 4
Press Return to terminate autoinstall and continue with manual configuration.
Several messages are displayed, ending with a line similar to the following:
Example:
...
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled <
date
> <
time
> by <
person
>
Step 5
Press Return to bring up the Router> prompt:
Example:
...
flashfs[4]: Initialization complete.
Router>
Step 6
Enter privileged EXEC mode:
Example:
Router>
enable
Cisco 450 Voice Gateway Hardware Installation Guide
26
Powering On the Cisco VG450 Voice Gateway
Power-On Procedure
