3
Connect the Hub to Other Network Devices
(continued)
RATING
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
CONSOLE
UP
MEDIA MODULE
DOWN
DC INPUT
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
10/100 BASE-TX
STAT DUP 100
RATING
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
CONSOLE
UP
MEDIA MODULE
DOWN
DC INPUT
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
10/100 BASE-TX
STAT DUP 100
RATING
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
CONSOLE
UP
MEDIA MODULE
DOWN
DC INPUT
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
DUP
LINK
100 BASE-FX
RX
TX
(Optional) Install the
Switched Uplink Module in
the Hub
1
Power off the hub.
2
Remove and set aside the screws
attaching the faceplate to expansion slot
on the hub. The screws will be used later
in Step 6.
3
Remove the faceplate from the hub and
store it for future use.
4
Slide the module into the slot
card-guides until you feel it touch the
back of the hub.
5
Push the module firmly until it snaps
into place and is firmly seated.
6
Insert and tighten the screws on the
module faceplate.
7
Power on the hub.
(Optional) Connect to the
Switched Uplink Module
Port
Insert a connector according to the type of
module (10/100 or 100BaseFX), as follows:
•
10BaseT/100BaseTX connector—Insert
the connector until it snaps into place in the
module port
.
Note: Use a straight-through cable to
connect two ports when one of the ports is
designated with an
X
. Use a crossover cable
to connect two ports when both ports are
designated with an
X
.
•
100BaseFX SC connector—Remove the
rubber plugs from the fiber-optic port
on the module and store them for future
use. Insert the connector in the
fiber-optic module port.
