2-17
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
OL-8914-02
Chapter 2 Switch Installation
Installing and Removing SFP Modules
Step 4
Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear
of the slot. (See
Figure 2-11
.)
Figure 2-11
Installing an SFP Module into an SFP Module Slot
Removing SFP Modules from SFP Module Slots
To remove an SFP module from a module receptacle, follow these steps:
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the enclosure.
Step 2
Disconnect the cable from the SFP module.
Tip
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Step 3
For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the
optical interfaces clean.
Step 4
Unlock and remove the SFP module, as shown in
Figure 2-12
.
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Figure 2-12
Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
153384
23x
24x
21x
24x
17x
18x
17x
20x
17
20
SYST
STAT
DLX
SPD
CONSOLE
UID
WS-CBS-3020-H
PQ
MODE
MEDIA D
ETECT SF
P/R-45 PO
RTS 17-20
17
20
18
19
1
Bale clasp
153385
23x
24x
21x
24x
17x
18x
17x
20x
17
20
SYST
STAT
DLX
SPD
CONSOLE
UID
WS-CBS-3020-HPQ
MODE
MEDIA D
ETECT SFP/R
-45 PO
RTS 17-20
17
20
18
19
1
