2-17
VPN 3000 Series Concentrator Getting Started
78-15733-03
Chapter 2 Installing and Powering Up the VPN Concentrator
Beginning Quick Configuration
Step 10
The system prompts you with a menu to set the transmission mode for the Ethernet 1 interface. You can
let the VPN Concentrator automatically detect and set the appropriate mode (the default), or you can
configure the interface for full duplex (transmission in both directions at the same time) or half duplex
(transmission in only one direction at a time). If you accept the default, be sure that the port on the active
network device (hub, switch, or router) to which you connect this interface is also set to automatically
negotiate the transmission mode. Otherwise, select the appropriate fixed mode.
1) Enter Duplex - Half/Full/Auto
2) Enter Duplex - Full Duplex
3) Enter Duplex - Half Duplex
Quick -> [ 1 ] _
At the cursor, enter the menu number for your selection; for example, 2. To accept the default (1), press
Enter
.
Step 11
The system prompts you to enter a value for the maximum transmission unit (packet size) for this
interface. Either accept the default value, 1500 bytes or specify a value in the range 68 to 1500. The
standard MTU for Ethernet is 1500 bytes.
> MTU [68-1500)
Quick --> [1500]_
Step 12
The system now has enough information so that you can exit the CLI and continue configuring with a
browser. The system displays one of the following menus, depending on the model of the Concentrator
being configured:
Model 3005 menu
1) Modify Ethernet 1 IP Address (Private)
2) Modify Ethernet 2 IP Address (Public)
3) Save changes to Config file
4) Continue
5) Exit
Quick -> _
Model 3015–3080 menu
1) Modify Ethernet 1 IP Address (Private)
2) Modify Ethernet 2 IP Address (Public)
3) Modify Ethernet 3 IP Address (External)
4) Save changes to Config file
5) Continue
6) Exit
Quick -> _
First, we recommend that you save your entries to the configuration file. At the cursor, enter the number
for Save changes to Config file. The system redisplays the same menu.
•
For easiest use, we recommend exiting and using the Manager. To do so, enter the number for Exit
at the cursor and continue with the next step.
•
To continue using the CLI for quick configuration, enter the number for Continue at the cursor and
see Chapter 4.
Step 13
We assume you chose Exit. The system displays:
Done
