4-13
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
show ip interface
brief
Example:
Router# show ip interface brief
Displays a brief status of the interfaces that are configured
for IP.
•
Determine which type of Ethernet interface is on your
router.
Step 3
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 4
interface
{
fastethernet
|
gigabitethernet
}
0/
port
Example:
Router(config)# interface gigabitethernet 0/0
Specifies the Ethernet interface and enters interface
configuration mode.
Note
For information on interface numbering, see the
software configuration guide.
Step 5
description
string
Example:
Router(config-if)# description GE int to 2nd
floor south wing
(Optional) Adds a description to an interface configuration.
•
The description helps you remember what is attached to
this interface. The description can be useful for
troubleshooting.
Step 6
ip address
ip-address mask
Example:
Router(config-if)# ip address 172.16.74.3
255.255.255.0
Sets a primary IP address for an interface.
Step 7
no shutdown
Example:
Router(config-if)# no shutdown
Enables an interface.
Step 8
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 9
show ip interface
brief
Example:
Router# show ip interface brief
Displays a brief status of the interfaces that are configured
for IP.
•
Verify that the Ethernet interfaces are up and
configured correctly.