CIS VCC-16MV02, Техническое описание и руководство по эксплуатации

Страница: 12 / 35

VCC-16MV02 Rev.905-0163-00
©2018 CIS Corporation. All rights reserved.
11
Serial Communications
Baud Rate Selection
※
INIT command is excluded.
14 0 9,600baud
1 115,200baud
Black Level Adjustment 16 0 ~ 100 Black level adjustment (With INIT command, it is restored to
factory-settings)
Gain 20 0 0dB fixed gain
1 + 6dB fixed gain
2 +12dB fixed gain
3 +18dB fixed gain
4 +24dB fixed gain
5 +30dB fixed gain
6 +36dB fixed gain
11 Manual gain (Refer to the address 21)
Manual Gain 21 0 ~ 480 0 ~ + 48dB (1dig=0.1dB)
Shutter 23 0 ~ 15 Preset shutter (Please refer to The List of Preset Shutter )
16 Manual shutter (Please refer to the address 24)
Manual Shutter 24 1 ~ 3000 1line/step (Please refer to Formula to Calculate Manual Shutter
Values )
Manual Shutter (At FAST trigger) 24
40 15 ~ 200,000 Specify exposure time with μs (approximate value).
Please refer to the manual shutter settings of FAST trigger mode
(CLK sync mode)
Gamma ON/OFF Selection 0 OFF (Bypass)
Gamma ON/OFF Selection
Gamma coefficient Selection 40
41 1 Gamma correction ON
0 ~ 15 Gamma coefficient 0 : 0.1 ~ 15 : 1.6 (per 0.1)
Vertical Partial (Lump Settings) 50 3 parameters The 1 st parameter: Partial number (0 ~ 7)
The 2 nd parameter: Start line (0 ~ 2996 per 4 lines)
The 3 rd parameter: Effective line numbers (4 ~ 3000 per 4 lines)
Vertical Partial (Lump Settings)
Vertical Partial Mode 50
54 1 parameter at
acquisition Specify the partial numbers (0 ~ 7).
0 OFF
When in operation, the cursor is reset
to (0, 0). 1 Reflect the value set by the address 50, and then set vertical partial
ON.
Factory Settings INIT None Restore the settings to the factory settings.
Data Save SAVE None Save the camera settings
White Defect Detection by Users 100 2 Parameters Detect the later occurred white defects and register them.
Addition of defective Pixels by Users 101 2 Parameters Register the defective pixels specified with (x, y).
Deletion of defective Pixels by Users 102 2 Parameters Delete the defective pixels specified with (x, y).
Complete Deletion of defective Pixels
by Users 103 1 (fixed) Delete all the defective pixels detected and registered by the user.
Indication of defective Pixels 104 0 at set up Turn OFF the indication of bright point
1 at set up Indicate the position of the correcting pixels with lighting.
1 at acquisition Indicate the list of data at ex-factory and the registered data by the
user.
2 at acquisition Indicate only the list of the registered data by the user.
3 at acquisition Indicate the registered number of the defective pixels per reed.
4 at acquisition List up and indicate the registered number of the defective pixels
per reed.