CIS VCC-16MV02, Техническое описание и руководство по эксплуатации

Страница: 11 / 35

VCC-16MV02 Rev.905-0163-00
©2018 CIS Corporation. All rights reserved.
10
5. Camera Function Settings
Camera functions can be set with serial communications.
Function Address Data Description
Camera Mode 1 0 2Tap 8bit/10bit
1 4Tap 8bit/10bit
2 8Tap 8bit/10bit
3 10Tap 8bit
Output Data Selection 2 0 8bit output
1 10bit output (Invalid at 10Tap mode)
Trigger Shutter Mode
※
FAST trigger mode is forced to be
disabled at normal shutter mode.
To enable FAST trigger mode, fixed
trigger shutter mode or pulse width
trigger shutter model shall be
selected.
3 0 Normal shutter mode (Free-run)
(Shutter speed can be set with address 23 and 24).
1 Fixed trigger shutter mode
(Shutter speed can be set with address 23 and 24)
2 Pulse width trigger shutter mode
(Shutter speed can be set with trigger pulse width).
Trigger Polarity 4 0 Positive
1 Negative
Trigger Input 5 0 Camera Link CC1
1 12pins circular connector No.11 pin (TTL)
FAST trigger mode selection
※
Trigger mode to capture the trigger
input with H cycle or the mode to
capture the trigger input with CLK
sync is switchable.
However, please be noted that
overlapped operation cannot be
operative at CLK sync mode.
This mode is effective to avoid hunting
at high-speed shutter operation.
6 0 H sync. mode (Trigger is taken with H sync.)
※ A trigger during outputting images can be input (Overlap
operation is doable).
※ Exposure time during normal shutter mode and fixed
trigger shutter mode can be set per H.
1 FAST trigger mode (Trigger is taken with CLK sync.)
※ A trigger during outputting images cannot be input (Overlap
operation is not doable).
※ Exposure time of manual shutter during fixed trigger
shutter mode is changed to be set per μs (approximate value).
Test Pattern 7 0 OFF
1 Gray scale (Valid only when cursor is OFF)
2 Horizontal ramp waveform (Valid only when cursor is OFF)
3 Vertical ramp waveform (Valid only when cursor is OFF)
Cursor Display 8 0 OFF
1 ON (Cursor output has its priority when test pattern output is ON)
Cursor X Coordinate 9 0 ~ 4095 Horizontal 4096 pixels (Factory setting is 0. When operating
coordinate, it is reset to 0.)
Cursor Y Coordinate 10 0 ~ 2999 Vertical 3000 lines (Factory setting is 0. When operating
coordinate, it is reset to 0.)
Output Image Horizontal Flip 11 0 Normal
When in operation, the cursor is reset
to (0, 0). 1 Horizontal flip
Output Image Vertical Flip
When in operation, the cursor is reset
to (0, 0). 12 0 Normal
1 Vertical flip
Defective Pixel Correction 13 0 OFF
1 ON