Cirrus Screens Harbour 2, Руководство по установке

Страница: 10 / 15

Cirrus Screens are designed to provide many years of trouble-free use. After the screen is installed and
adjusted, no further maintenance is required for the operation of the screen, unless the viewing surface
gets dirty. Follow these guidelines to clean any marks or residue from the viewing surface:
•
Do not clean the screen case with water
•
Wash the case with a mild organic cleaner diluted with water and ensure to clean the entire
screen not just one spot.
•
Use a dry Microfiber cloth to clean dust and dirt from the housing and screen on regular
occasions.
Table 1 RS232 Command Structure
OUTPUT HEX VALUE
UP 0xFF, 0xEE, 0xEE, 0xEE, 0xDD
DOWN 0xFF, 0xEE, 0xEE, 0xEE, 0xEE
STOP 0xFF, 0xEE, 0xEE, 0xEE, 0xCC
The Cirrus Screens motorized screen may also be controlled via contact closure or relay control.
1. Run a Cat5e/6 cable from the control system processor location to the projection screen.
2. Cut the RJ12 cable and leave about 12” of cable attached to the connector.
3. Terminate conductors in the Cat5e/6 to the desired pins of the RJ12 connector as shown in the diagram
below. Insulate the ends of the unused RJ12 conductors to prevent short circuits.
4. Terminate the same conductors to the appropriate wires on the RS232 port or contact/relay connection of
the control system processor.