goldstrike Shock & Awe
®
2.0
Parts Included:
WARNING:
This indication alerts you to the
fact that ignoring the contents
described herein can result in
potential serious injury or death
if not followed.
CAUTION:
This indication alerts you to the
fact that ignoring the contents
described herein can or will
result in material damage
and/or personal injury.
ATTENTION:
This indication alerts you to the
fact if you ignore this detail you
will affect the performance or
functionality of the product.
All Ciro products are designed
for "easy assembly" and/or "plug
and play". We recommend a
competent mechanic install our
products, using standard
mechanical procedures to
assure a safe and successful
installation.
G0048031, REV. -
1
Bluetooth Controller
15
3” LED Flex Pods
2
8” Wiring Extensions
9
22” Wiring Extensions
9
Y-splitters
1
Installation Kit
INSTALLATION INSTRUCTIONS:
1. Park on a level surface and shut off the motorcycle. Ensure the engine has time to cool before installation.
2. Download Ciro Shock and Awe app from the Apple iTunes or Google Play store to utilize Bluetooth features. For
instruction on how to use the app, search “Ciro Shock and Awe App Tutorial” on YouTube.
3. Remove seat.
4. Determine 12 volt power source that is either constant or switched, depending if you would like Ciro Shock & Awe
LEDs to always stay on or turn off with the motorcycle.
Note: The Bluetooth controller will draw about 30 milliamps in standby mode. Without use of a battery
trickle charger or periodic starting of the engine, slight battery drain may occur. You can wire controller to
key-on power on the motorcycle if battery drain is a concern.
5. Connect controller harness to your choice of power source and mount in desired location. Reference pictures for
recommended locations. Red ring terminal to positive 12v source, and black ring terminal to negative ground. Before
applying switch adhesive, wipe area clean with an ammonia-based cleaner and allow to dry. A clean surface ensures
better adhesion. Firmly hold in place for 60 seconds. Adhesive fully cures within 24 hours.
6. The controller will support up to 3 separate lighting channels controlled through the APP. The outputs of the
controller vary in length, the shortest being channel 1, the mid-length is channel 2, the longest output is channel 3.
7. Temporarily connect a LED flex pod to each of the channel you intend to use. Test the function of each through the
use of the APP. Be sure to understand the functions will be suitable for your intended locations.
8. Determine placement for the LED flex pods on your motorcycle. Temporarily position the LED flex pods in place
with customer supplied masking tape or other suitable method.
9. Route wiring extensions to LED flex pod locations. Place a small amount of dielectric grease on each connector
before plugging in. Reference pictures for recommended locations. If placing strips and pods in the recommended air
cleaner and horn locations, use included y-splitters.
Note: Throughout the wiring process, leaving the power source on will guarantee that power is reaching all
strips and pods. Do not allow the wires to contact hot surfaces or other possible pinch points.
Damaged wires are the most common type of problem experienced and can lead to unexpected results.
10. Make final adjustments to LED flex pod locations and wire paths. Prior to adhering LED flex pods, use ammo
-
nia-based cleaner to wipe away any dirt and allow to dry. Press LED flex pods firmly into position, hold for 60 seconds.
11. From the installation kit; use adhesive backed cable tie mounts and cable ties as necessary. Additional pieces of
adhesive and clips can be used to hold wires and connectors in position on the motorcycle.
12. (Optional) To utilize the brake override function connect loose red wire of the controller to the brake light circuit
of the motorcycle using supplied posi-tap connector or other suitable method. A factory service manual or test light
may be required to identify the proper connection location.
13. Reinstall seat.
