----------- TCP2RS -------------- User’s manual -------------------- page 27/43
27
5.2.3 Monitor Mode Commands
The following commands are available in Monitor Mode. Many commands have an IP
address as an optional parameter (x.x.x.x). If the IP address is given, the command is
applied to another Device Server with that IP address. If no IP address is given, the
command is executed locally.
Note:
All commands must be given in capital letters, with blank spaces
between the parameters.
Table 5-1:
Monitor Mode Commands
Command
Command Name
Function
DL
Download
Download firmware to the TCP2RS
SF x.x.x.x
Send Firmware
Send firmware to Device Server with IP
address x.x.x.x
VS x.x.x.x
Version
Query software header record (16-byte) of
Device Server with IP address x.x.x.x
GC x.x.x.x
Get Configuration
Get configuration of Device Server with IP
address x.x.x.x as hex records
SC x.x.x.x
Send Configuration
Set configuration of Device Server with IP
address x.x.x.x from hex records
PI x.x.x.x
Ping
Ping Device Server with IP address x.x.x.x to
check device status
AT
ARP Table
Show the TCP2RS’s ARP table entries
TT
TCP Connection Table
Shows all incoming and outgoing TCP con-
nections (used only with monitor mode)
NC
Network Connection
Shows the TCP2RS’s IP configuration
RS
Reset
Resets the TCP2RS’s power
SI x.x.x.x:n.n.n.n
Send/Set IP Address
Remotely assign an IP address to a Device
Server, where x.x.x.x is the new IP address
and n.n.n.n is the remote Device Server’s
serial number written twice
QU
Quit
Exit diagnostics mode
Entering any of the commands listed above will generate one of the following command
response codes:
Table E-2:
Command Response Codes
Response
Meaning
0>
OK; no error
1>
No answer from remote device
2>
Cannot reach remote device or no answer
