Circutor Q20711, Руководство пользователя

Страница: 33 / 36

Page
32
B. Appendix: Installation and start up of the QNA-GPRS.
Steps to be followed when setting the QNA analyzer so that it sends recorded
information via GPRS to an FTP server.
1- Apply power supply voltage to the QNA (it is important that when this is done, the
RS-232 communications cable is not connected. If it is, then the modem will not start
correctly).
2.-Wait for about 2 minutes so that the equipment starts the modem. Press the two
keys at the same time until the screen display the message “SIGNAL XX”, XX being
equal to the value of the existing cover (this may be between 0 and 30). When this
message appears, it means that the modem start up process has been correctly
carried out.
3.- Connect the RS-232 communications cable to the equipment.
4.- Using the PowerVision software, enter the device’s general parameters and then
press “GPRS”.
5.- The following message will then appear on the screen to allow the GPRS
parameters to be changed:
IP of the FTP server from
which the information is to be
downloaded
User name
and password for the
FTP Server file to
where the information
is to be downloaded.
This information is supplied by the telephone
company. For example, Vodafone in Spain has the
access point server:
airtel.es . The user name and
password is: vodafone in both cases.
Indicates the frequency in which the
QNA is to send information to the server
Indicates the date of the first piece of
information sent. Every X hours from then on
(as indicated in the frequency) a file is sent to
the FTP server with the information.