Circutor DH96-CPP, Руководство пользователя

Страница: 10 / 22

WARNING
Proceed as pictures show below:
: Insure that no incoming
wire is connected to the equipment before
doing any manipulation work on the
equipment, since observed failure in the
equipment can provoke equipment
damages and even serious injury.
1) Press the case holding piece with a
screwdriver or a similar tool in order to
release the base from the rest of the case.
2) Remove the set composed by the
base and circuits by pulling the base and
carefully sliding it out.
3) Insert the card into the suitable
connector. Take care that only the
connector is pressed but not all the card.
4) Put the set composed by the base
and circuits in, again, by pushing the base
and carefully sliding it inside. When the set
is totally inserted, press until the case
holding pieces are fitted into the pertinent
holes.
Plug-in cards
Page 10
1)
2)
3)
4)
Chapter
2
Inst
allation
and
st
artup