Circutor CEM-C30, Инструкция по эксплуатации

Страница: 26 / 40

4�7�5� Type of communications
Note: This is only displayed if there is a
CEM M-RS485
(communications interface for the CEM
family of units) connected to the unit.
This is the home screen for selecting the number of bits, the
parity and the number of stop bits of the communications frame.
Long press the button to view the value to be programmed.
This screen shows the different options:
8n1 : 8 bits, no parity, 1 stop bit.
8E1
: 8 bits, even parity, 1 stop bit.
8o1
: 8 bits, odd parity, 1 stop bit.
8n2
: 8 bits, no parity, 2 stop bits.
8E2
: 8 bits, even parity, 2 stop bits.
8o2
: 8 bits, odd parity, 2 stop bits.
Short press the button to browse the different options.
To validate the data, long press the button and the validation screen will appear
(
Figure 13
) indicating that the programming value has been saved.
After a few seconds viewing the screen shown on
Figure 13
, the system returns to the
Communications type programming main screen.
Short press the button to access the next programming step.
4�7�6� Energy cost
This is the home screen for entering the energy cost per kWh.
Long press the button to view the value to be programmed.
To write or modify the value, short press the button
repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the button, allowing the remaining values to be modified.
26
CEM-C30
Instruction Manual