Circutor CEM-C10, Инструкция по эксплуатации

Страница: 21 / 36

4�7�5� Type of communications
Note:
This is only displayed if there is a
CEM M-RS485
(communications interface for the
CEM
family
of units) connected to the unit.
This is the home screen for selecting the number of bits, the parity
and the number of stop bits of the communications frame.
Long press the key to view the value to be programmed.
This screen shows the different options:
8n1 : 8 bits, no parity, 1 stop bit.
8E1
: 8 bits, even parity, 1 stop bit.
8o1
: 8 bits, odd parity, 1 stop bit.
8n2
: 8 bits, no parity, 2 stop bits.
8E2
: 8 bits, even parity, 2 stop bits.
8o2
: 8 bits, odd parity, 2 stop bits.
Short press the key to browse the different options.
To validate the data, long press the key and the validation screen will appear (
Figure 11
) indicating
that the programming value has been saved.
After a few seconds viewing the screen shown on
Figure 11
, the system returns to the
Communications
type
programming main screen.
Short press the key to access the next programming step.
4�7�6� Display
This is the home screen for selecting the unit display options.
Long press to access the partial energy display selection screen:
4�7�6�1� Partial energy display
This is the home screen for selecting the partial energy display view
option.
21
Instruction Manual
CEM-C10