Circor IMO 3220/523, Руководство по обслуживанию изделия

Страница: 7 / 14

7
G. PARTS LIST
Table 2 – Pump Parts List
IDP QTY DESCRIPTION KIT IDP QTY DESCRIPTION KIT
1 1 Case 42 2 Bearing Retaining Ring X
2 1 Inlet Head 43 1 Bearing Retainer
3 2 Dowel Pin 46 1 Inboard Cover
4 16 Case Bolts 47 4 Bearing Retainer Bolts
6 1 Stop Pin XX 48 1 Seal Seat Adapter
7 1 Dyna Seal X 49 1 Ball Bearing X
8 2 Housing Retaining Ring XX 63 1 Power Rotor XX
9 1 Inlet O-Ring X 66 1 90° Elbow
67 2 Pipe Plug
21 2 Suction Idler XX 68 1 Nipple
22 1 Idler Stop XX 69 1 Tube Fitting
23 2 Thrust Cups XX 70 1 90° tube to MNPT fitting
24 1 Discharge Housing XX 71 1 Seal Pipe
25 1 Seal X 73 1 Suction Housing XX
26 3 Tube XX 79 1 Floating BP Bushing XX
27 4 Tube O-Ring X 80 1 Seal Seat Adapter O-Ring X
28 2 Housing O-Ring X 81 1 Cap Screw
29 1 Thrust Cage XX 91 16 Hardened Washers
38 1 Seal Spacer 102 1 Orifice Plug
X = Minor Repair Kit Items.
XX = Major Repair Kit Items. (Items marked (X) are included in Major Repair Kit).
H. PUMP MAINTENANCE
WARNING
Failure to observe precautions while installing, inspecting and maintaining pump can cause
injury to personnel from accidental handling of liquids that may harm skin or clothing, or fire
hazard risks from flammable liquids, or injury from high pressure fluid jets.
DANGER
BEFORE working on equipment, make sure all power to equipment is disconnected and
locked-out.
H.1 GENERAL COMMENTS
Part number identifiers contained within parenthesis such as (10) refer to circled numbers shown
on assembly drawing, Figure 4 and Table 2.
H.2 TOOLS REQUIRED
Procedures described in this manual require common mechanics hand tools, a torque wrench, dial
indicator and suitable lifting device (such as) slings, straps, etc.
H.3 DISASSEMBLY
PROCEDURES
SPECIAL NOTE: To service mechanical seal and ball bearings ONLY perform H.3, Steps 1, 7,
8 and 9 and H.4, Steps 8, 9, 10 and 11 ONLY .