Circontrol Wallbox eNext Series, Руководство по установке

Страница: 9 / 36

05
I M P O R TA N T C H A R G E P O I N T S A F E T Y I N S T RU C T I O N S
Read carefully all the instructions before starting in or-
der to ensure properly installation of the Charge Point.
Before installation
The Charge Point is designed for installation in indoor and outdoor areas. For each of the different
conditions of installation, the unit shall be installed safely and assuring the adequate protections
• Charge Point must not be installed in
areas where potential risk of explosions
are.
• Do not install the Charge Point where
falling objects may damage the
equipment.
• The Charge Point can be installed in
locations with non-restricted access.
• The surface where the Charge Point is
placed must withstand the mechanical
forces.
• This unit shall not be used for any other
purpose than electric vehicle charging
modes as specified in IEC 61851.
• Do not modify this unit. If modified,
Circontrol will reject all responsibility
and the warranty will be void.
• The Charge point does not support the
ventilation optional function described
in IEC 61851-1:2017 (clause 6.3.2.2)
• Do not use any adapter, except those
approved by the EV manufacturer.
Only socket-outlet EV plug adapter is
allowed:
• Do not perform any repair o manipulation
of the unit while it is energized.
• Only trained and qualified personnel
should be able to access to low-voltage
electrical parts inside the unit.
• Check the installation annually by
qualified technician.
• Remove from service any item which
have a fault that could be dangerous
for users (broken plugs, caps that don’t
close...).
• Use only Circontrol supplied spare parts.
• Do not use this product if the enclosure
or the EV connector is broken, cracked,
open, or shows any other indication of
damage.
Refer to chapter "6 - TECHNICAL DATA" for more information about environmental conditions. .