Cima BLITZ 45T, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 72

4
BLITZ 5-1996
5 - 95015 - BEFORE USING THE RELEASE, STOP THE TRACTOR TAKE THE KEY OUT OF THE
CONTROL PANEL AND MAKE SURE THAT THE FAN HAS STOPPED.
- Position: on the cover of the gearbox protection guard.
6 - 95010 - MAXIMUM WORKING SPEED OF THE POWER TAKE-OFF: 540 RPM.
- Position: near the power take-off (PTO).
7 - 95007 - DANGER: SPRAYS. REMAIN AT A SAFE DISTANCE.
- Position: on the frame rear, left part.
8 - 95006 - ATTENTION: CONSULT THE USE AND MAINTENANCE MANUAL BEFORE USE OR WORK ON
THE MACHINE.
- Position: in the front part of the machine, on the tank's hood.
9 - 95009 - DANGER: USE PROTECTIVE GLOVES WHILE EMPTYING THE TANK.
- Position: on the machine's left-hand side, near the three-way tap.
9* - 95009 - DANGER: USE PROTECTIVE GLOVES WHILE EMPTYING THE TANK.
- Position: on the machine's left-hand side, near the three-way tap.
10 - 95055 - ATTENTION: THE MACHINE IS NOT APPROVED FOR DRIVING ON THE ROAD.
- Position: on the left-hand part of the tank front..
11 - 95059 - 3 HOOKING POINTS FOR LIFTING THE MACHINE
- 2 points are located on the lateral guards in the front part of the machine, and 1 is on the rear bracket
for fastening the distribution devices.
Use and maintenance
12 - 95052 - GREASE EVERY 20 HOURS: FAN SHAFT BEARINGS
- Position: on the frame, front left part.
13 - 95053 - GREASE EVERY 50 H0URS: FAN BELT STRETCHER SUPPORT
- Position: on the frame, front left part.
14 - 95054 - GREASE EVERY 200 HOURS:
1-FREEWHEEL - position: on the front part, near the PTO protection guard.
2-BEARING FOOT - position: under the adjustment crank.
3-WHEEL HUBS - position: on the hubs.
15 - 95067 - OIL EVERY 50 HOURS: PUMP BEARINGS.
- Position: On the left-hand side of the multiplier unit protection guard, near the pump.
15* - 95067 - OIL EVERY 50 HOURS: PUMP BEARINGS.
- Position: On the right-hand side of the multiplier unit protection guard, near the pump.
16 - 95057 - HANDWASH TANK TAP
- Position: on the handwash tank, left-hand side.
17 - 95065 - ATTENTION: NEVER LET THE ATOMIZER RUN WITHOUT LIQUID INSIDE THE TANK
- Position: left-hand side of the tank.
18 - 95063 - INSTRUCTIONS FOR USE AND MAINTENANCE OF THE ELECTROVALVES
- Position: on the rear right-hand side of the frame.
19 - 95060 - WHEEL OPERATING PRESSURE
95056 - Position: on the tank's sides above the wheels. See appropriate Table at point 4.5.2.
20 - 95070 - OPERATION OF THE THREE-WAY VALVE
- Position:left-hand side, near the valve.
21 - 95071 - OPERATION OF THE THREE-WAY VALVE
- Position: right-hand side, near the valve of the additional pump.
THE 5-FIGURE NUMBERS ARE THE CODES TO BE USED FOR ORDERING DECALS.