CID Bio-Science CI-202, Инструкция по эксплуатации

Страница: 18 / 34

CI-202 Instruction Manual rev. 6/21/2017
1554 NE 3
rd
Ave, Camas, WA 98607, USA
Phone (360) 833-8835 Fax (360) 833-1914 sales@cid-inc.com http://www.cid-inc.com
17
23) The motor will start,
and you will see the “t” and “w” settings appear. Use the UP or
DOWN arrow keys to
adjust your “t” value to your average setting number (from step
21).
24) Press STOP TWICE and then SAVE. This will save your threshold settings.
25)
Use the DOWN arrow key to get to “Measure file01.” Make sure the scan area is clean
and clear.
26) With the laser over the reflective material only, press the RIGHT and LEFT arrows
simultaneously. You will hear the motor run briefly and stop. DO NOT MOVE THE
SCANNER WHILE IT IS RUNNING.
27) Press the RIGHT and LEFT arrow keys simultaneously one more time. This will
calibrate the unit for the Root Mode. (Note: You will follow the same instructions shortly
to calibrate the instrument in Leaf mode).
28)
Use the UP or DOWN arrow to get to the “Set-up Scanner” and then the RIGHT arrow
to get to “Setup Measure.” Press ENTER.
29) Use th
e UP or DOWN arrows to change the setting to “Measure Leaf.” Press SAVE.
The screen will flash “Measure = leaf saved.”
30)
Use the UP or DOWN arrow to get to “Set-up Measure.”
31)
Use the RIGHT or LEFT arrow to get to “Set-up Scanner.”
32) Press ENTER.
33) Use the UP
or DOWN arrow to get to “HiThld Scan.” Press ENTER.
34)
You will see the “t” value on the left and the “w” value on the right. The values will
drop.
Watch the “T” value and note when the numbers stop, and the setting is locked.
Note and write down the number.
35)
Use the UP or DOWN arrow to get to “LoThld Scan.” Place a white sheet of paper
under the scan area. Press ENTER.
36)
You will notice again the “t” value will drop. Note and write down the number
37) Add the two threshold values together and divide by 2. This will give you the average.
Remove the white paper.
38)
Use the UP or DOWN arrow to get to “Manual Scan.” Press ENTER.
39)
Using the UP or DOWN arrow, adjust the “t” value to the average setting computed in
step 37.
40) Press STOP TWICE and then press SAVE. This will save your threshold setting for the
Leaf mode (the screen will flash “Leaf params saved” indicating that the changes
made to the leaf parameters were saved).
41)
Press the DOWN arrow until the screen displays “Measure file01.”
42) Press the LEFT and RIGHT arrows simultaneously. This will compute the Timing
parameters for the unit. REPEAT this step.