Chungho Super Iguassu ice, Руководство пользователя

Страница: 9 / 24

9
4 4.. IIn nsstta alllla attiio on n P Prre ecca au uttiio on nss
●
Our company's technician will perform the installation. You, as the customer should check if the
product was properly installed.
When installing the product, do not install it at the following places.
•
Near fire
•
Near flammable material
•
Wet place
• A place exposed to rain and snow • A place exposed to direct sunshine
•
Near chemicals(volatile material, organic solvent, etc.)
•
Dark place
• A place below 32 ℉ (0 ℃ ) or a place with the possibility of dropping below 32 ℉ (0 ℃ ).
※
When the product is installed in a dark place, and the power saving function is
set, then hot the water system may not operate even during daytime.
(Install it at bright place.)
1
When transporting the product, do not tilt it over 45 ° .
※
Severe tilting can be the cause of reduced performance.
2
Install the product at a place where the surface is level, and after installation,
always attempt to adjust the level of the product using a level gauge.
※
Tilting of the product can reduce water purification performance and ice making
capability.
3
Leave approximately 8 in(20cm). between the wall, sides and rear surfaces of the product
so that ventilation may be smoothly performed for safe operation of product.
※
This can be the cause of reduced performance and complications.
4
Do not install the rear of the product near any heat radiating plates at rear surface. 5
Use the following water quality range.
•
Water pressure : 7~120psi(0.5~8.4kgf/
㎠
)
•
Water temperature : 39~100
℉
(4~38
℃
)
• pH : 5~10 • Hardness : 300ppm or less • Evaporated remains : 500ppm or less
•
Water quality : Biologically safe water quality
※ When using another water quality than the above, discuss it with our company.
※ If you do not use water quality within the above range without prior discussion
with our company, the product can be excluded from the stated warranty period.
6
Do not connect hot water(over 100
℉
(38
℃
)) to this product.
※
This can be the cause of trouble and decline in ice making performance.
7