Chungho CHP-5321D, Руководство пользователя

Страница: 10 / 28

09
4. Installation method
●
Service engineer install the unit. You should check if the unit is properly installed.
1
2
3
10
6
8
9
4
7
5
Connect tube to brine hole on the back of the unit. And then, place tube to drain
hole such as sink, toilet etc.
※ Brine water can easily be used for other purposes, such as bathroom
cleaning, house cleaning, laundering, washing, etc.
※
Never use the drainage water for drinking or cooking.
Empty the water in the tank when "WATER FULL" lights on.
Turn on water supply valve connected to the house and position the adapter
(Source water valve) "OPEN".
Do not plug in the power for 30 minutes in order to stabilize the cooling system
and safe use of unit.
Check if water is supplied into the unit properly and there are any leakages on
every connection.
Check every connection part for leaks.
After 1 hour has passed from supplying the power, check if water is coming out
by pressing the water dispensing button.
Install horizontally.
Shut off water supply valve and separate the connector part of tap water in order to
connect an adapter(Source water valve). Then, connect the adapter (Source water valve).
※
If a sealing rubber(packing) is missing or the thread of a screw is damaged,
it may occur water leakage.
※
The unit is recommended to install on the sink or table above 80 cm from
the floor.
Connect the adapter (Source water valve) and a water inlet on the rear of the
unit with a tube.