09
10
Door/Window Contact
Door/window contact is for detection of the opening-closing state. If the system is set
to Arm and the transmitter is more than 2cm apart from the magnet, the panel will
receive an alarm signal from door/window contact and then sound the alarm.
AAA 1.5V
AAA 1.5V
2.5m
Transmitter
Magnet
Indicator Light
Tamper Switch
Note:
Indicator light flashes once: Door/window contact is triggered.
Flashes once after 2 seconds when triggered: The battery is running low. Please replace the
battery as soon as possible.
After pressing the Tamper Switch, the system will immediately sound the alarm.
Important!
Door/window Status Alert: When arm/ home arm the system without door/window
closed, the panel will sound “DiDi” to remind you for 15s. If press the Arm button
again, the sound will stop and system arm immediately.
PIR Motion Detector
PIR motion detector adopts digital dual-core fuzzy logic control processing technology
and an intelligent analysis algorithm. Upon detection of human body movement, the
panel will receive an alarm signal and then sound the alarm.
AAA 1.5V
AAA 1.5V
2.5m
Detection Window
Indicator Light
Note:
Indicator light flashes once: Motion is detected.
Flashes three times per second: The battery is running low. Please replace the battery as soon
as possible.
Working Mode
Testing Mode
After removing the insulating strip, the PIR motion detector will conduct a
self-inspection for around 1 minute and then enter testing mode. The detector carries
out detection every 10 seconds. After 3 minutes, the status indicator blinks twice, and
the detector switches to power saving mode.
Note:
Equipped with the batteries with pressing and holding the test button, the motion
detector will remain in the testing mode eternally. That is detecting every 10 seconds.
Reloading the batteries can exit this mode.
Power Saving Mode (Default Setting)
This product is designed with an intelligent power-saving mode. If human body
movements are detected twice within 3 minutes, it will be automatically switched to
sleeping mode to save power. Any movement within the detection zone will not turn
the light on or send an alarm signal. If no human body movements have been detected
after 3 minutes, the PIR motion detector automatically returns to the alert mode.
After self-inspection and a 3-minute testing
mode, detector enters power saving mode
If human body movements are detected twice within
3 minutes, the detector will automatically be switched
to sleeping mode.
No detection of human body movement for 3 minutes
Exit sleeping mode and enter
operating mode.
Tamper Switch
Test Button
