Chrysler Voyager 2001, Руководство по эксплуатации

Страница: 21 / 168

The power sliding door may be opened manually
or by using the buttons on the remote keyless
entry transmitter, switches on the overhead con-
sole or a switch located on the trim panel just in
front of the sliding door. To keep your door oper-
ating properly, observe the following guidelines.
•
Always open the door smoothly.
•
Avoid high impacts against the door stop when
opening the door manually. This is very impor-
tant when your vehicle is parked on an incline
as the door will slide faster in the downhill
direction.
•
There is a hold-open latch that is activated
when the sliding door is fully opened. This latch
will keep your sliding door open on any incline.
To close the power sliding door after the hold-
open latch is activated, you must press any one
of the power sliding door switches, push the
button on the inside grab handle or pull out on
the outside sliding door handle.
There are power sliding door switches located on
the trim panel just in front of the power sliding door
for the rear seat passengers. Pressing the switch
once will open the power sliding door, once the
door is fully open pressing the switch a second
time will close the door.
If the inside or outside door handles are used
while the power sliding door is activated, the
power sliding door feature will be canceled and
the door must be opened or closed manually.
To avoid unintentional operation of the power
sliding door from the rear seats, press the button
located in the overhead console to disable the
controls for the rear seat passengers.
NOTE:
•
If anything obstructs the power sliding door
while it is closing or opening, the door will
automatically reverse to the closed or open
position, provided it meets sufficient resis-
tance.
•
The driver’s side sliding door cannot be
opened while the fuel door is open. This
feature operates only when the sliding door
is fully closed prior to opening the fuel door.
•
The power sliding door must be in the full
open or close position for any of the
switches to operate. If the door is not in the
full open or close positions it must be
opened or closed manually.
•
The power sliding door switches will not
operate if the vehicle is in gear or the vehicle
speed is above 0 mph.
•
If the power sliding door encounters mul-
tiple obstructions within the same cycle the
system will automatically stop and must be
opened or closed manually.
WARNING!
You or others could be injured if caught in the
path of the sliding door. Make sure the door path
is clear before closing the door.
20