Chrysler 2005 Sebring, Руководство по обслуживанию, Страница: 534 / 3204

DECKLID RELEASE SWITCH
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove left lower instrument panel cover.
(3) Disconnect the wire connector.
(4) Pinch four tabs around side of decklid release
switch on the rear side of the left lower instrument
panel trim, and push switch through opening.
INSTALLATION
(1) Position the decklid release switch over open-
ing of the left lower instrument panel trim, and push
switch through opening.
(2) Connect the wire connector.
(3) Install the left lower instrument panel cover.
(4) Connect the battery negative cable.
KEYLESS ENTRY
TRANSMITTER
DIAGNOSIS AND TESTING - KEYLESS ENTRY
MODULE
Using special tool 9001, first test to ensure that
the transmitter is functioning. Typical testing dis-
tance is 2.5 centimeters (1 inch) for Asian transmit-
ters and 30.5 centimeters (12 inches) for all others.
To test, position the transmitter as shown (Fig. 2).
Press any transmitter button, then test each button
individually. The tool will beep if a radio signal
strength that lights five or more LED’s is detected.
Repeat this test three times. If transmitter fails any
of the test refer to the Diagnostic Procedures man-
ual.
STANDARD PROCEDURE - RKE TRANSMITTER
PROGRAMMING
The Remote Keyless Entry (RKE) Transmitter(s)
can be programmed with the use of the DRB III
!
scan tool, or by the customer.
New Remote Keyless Entry (RKE) transmitters can
be programed using the DRBIII
!
scan tool and the
proper Diagnostic Procedures manual, if no function-
ing transmitter is available. The DRBIII
!
scan tool
can provide confirmation that the PCI data bus is
functional, and that all of the electronic modules are
sending and receiving the proper messages on the
PCI data bus.
The following procedure can be used as long as one
functioning transmitter is available:
(1) Turn ignition to the RUN position (allow igni-
tion chimes to stop).
(2) Using any original (working) transmitter, press
the UNLOCK button for 4 to 10 seconds.
(3) Within the specified 4 to 10 seconds, continue
pressing the UNLOCK button and press the PANIC
button for 1 second, and release both buttons. A
chime will sound to indicate that the transmitter pro-
gramming mode has been entered (allow 3 seconds
for chime to sound).
(4) Press LOCK and UNLOCK buttons simulta-
neously for 1 second and release.
(5) Press and release any button on the same
transmitter and a chime will sound after successfully
programming the transmitter.
(6) Repeat steps 5 and 6 to program additional
transmitters.
(7) Turn ignition to the OFF position. Transmitter
programming mode will discontinue after 60 seconds.
All transmitter programming must be completed
within time specified.
SPECIFICATIONS
TRANSMITTER
BATTERY
The transmitter has two 3 volt batteries, which can
be removed and replaced without special tools. Insert
a dime in the side slot of the transmitter and twist.
the halves should separate and the batteries are
stacked on top of each other. The batteries are avail-
able at local retail stores. Recommended batteries are
Panasonic CR 2016 or equivalent. Battery life is
about two years.
RANGE
Operation range is within 12 meters (40 ft.) of the
module/receiver.
Fig. 2 RKE TRANSMITTER DIAGNOSIS
JR
POWER LOCKS 8N - 5