Chroma 63200 Series, Инструкция по эксплуатации и программированию

Страница: 73 / 126

Local Operation
RS-232C Connector
Pin Number Input/Output Description
1 ---
+
5V
2 Input RxD
3 Output TxD
4 Output DTR
5 --- GND
6 Input DSR
7 Output RTS
8 Input CTS
9 --- +5V
Note:
Pin 1 and pin 9 (
+
5V) are for 63200 series Remote Controller only.
External wave Enable. The Load current can be controlled by the external DC voltage
input via the Vext BNC connector on the rear panel if this function is selected 1: YES.
The default is 2: NO. The Ext. Wave LED will be lighted when operating in this mode.
EXT. WAVE ENABLE
1: YES 2: NO
Parallel mode function. The Loads can be used in parallel to increase the loading power
capacity. There is only one master in the parallel group, the rest are slaves. These Loads
can be operated synchronized in static or dynamic mode via the master control. There are
four different types for the Load to set in operation. There are maximum six models in
parallel.
PARALLEL = NONE
PRESS 0
→
3 TO SELECT
0: NONE:
Disable the parallel mode function.
1: MASTER: Used as the master for the parallel group, and this is the only one
controlled by front panel or PC in this group. Not only do the
synchronized operation, but also tell the slaves how many current they
should sink.
Measurement Display:
Choose 1. SUM to show the total current on the master or
2. Sole to show the current the loads owned.
SLAVE X MODEL:
Press 0
→
6 to setup the slaves’ model to use in parallel. NONE means
not exist.
2: SLAVE: Setup the Load as slave.
3: MASTER SYN: Same as 1: MASTER except this just do the SYNC parallel function, all
the loading data of the slaves is decided by the front panel or PC input.
4-19