Christie Spyder X20, Руководство пользователя

Страница: 153 / 172

Spyder Expansion
Spyder X20 User Manual 153
020-000916-01 Rev. 1 (04-2016)
Since the blended widescreen using an 800 x 600 preview will use 6,393,600 pixels it will be the first VI. The
existing two screens will require the second VI.
The user decision is to use the 240 with the first 344 (A) to enable the use of eight layers on the blended screen
which is the first VI. The other 344 (B) is the second VI and all four layers will be used as two mixers for the two
screens.
Connect the frames with their expansion cables in the following order of signal flow. Connect 240 to 344 (A) to
344 (B). The 240 will be the master frame and the two 344’s will be slaves.
Although layers from the first 344 (A) will not pass into the second 344 (B) the expansion cable is still required
for the creation of the expansion system. Make sure all frames are on the same network and connected.
Connect the first 8 outputs from the ISIS matrix switch to the 240 and 344 (A) and the next 4 to the second 344
(B). Connect the ISIS serial cable to a serial port on the 240.
Start the Advanced software on the client PC and select File/New. The Spyder Configuration Manager will open
and select Start with new empty configuration.
From the drop down menus select the matching IP address to frame in the order of the system starting from the
master frame which is the 240. If doing a system configuration off-
line choose ‘virtual’ instead of an IP address.
After the frames are selected choose NTSC for frame rate. Click Next .