![background image](http://html.mh-extra.com/html/christie/spyder-x20/spyder-x20_user-manual_2603460139.webp)
Spyder Hardware Family
Spyder X20 User Manual
139
020-000916-01 Rev. 1 (04-2016)
Power Control
The Spyder uses a soft power scheme. Pressing the Standby switch initiates a power up cycle and after a short
boot time the front panel display will indicate operational status. Pressing the Standby switch again initiates the
power down cycle after which the unit enters standby mode. There is a hard power switch on the rear that
should be used only when Spyder is in the standby state (Standby Switch LED is off).
The user should avoid disconnecting the primary power source (AC input) until the unit is in standby
mode. Failure to do this could result in hard drive data corruption.
Display
The Spyder enclosure is equipped with a status/error display located on the front panel. This is helpful in
determining proper start-up and shut-down of the unit, as well as indicating error messages. The following
diagram indicates the status when the unit has been booted up and has determined the version, frame, I/O
configuration and IP address.
Содержание Spyder X20
